Water Hardness Atlas ZIP / postcode

Well water hardness in San Bernardino County, California

7.6 gpg hard

Private wells in San Bernardino County typically give hard water: the median well sampled by the U.S. Geological Survey has 7.6 gpg (130 mg/L as CaCO₃).

<6060–120120–180>180 mg/L

Wells differ a lot, even next door: one in ten sampled wells had less than 25 mg/L and one in ten more than 351 mg/L. The figure comes from 1522 wells and 6020 samples taken between 1980 and 2023 (half of them by 2004).

Most samples are older than ten years. Groundwater hardness comes from the rock the well is drilled into and changes slowly, but your own well can be quite different, so treat this as a regional indication and test your water.

On city or town water instead of a well? Your utility publishes its own figures: Apple Valley (8.1 gpg), Victorville (5.5 gpg), Hesperia (4.4 gpg), Adelanto (8.5 gpg).

What this hardness means for a well household

How to test your well in California

Hardness is only one part of a well test. Federal health agencies advise every private well owner to test regularly:

Use a certified laboratory: California State Water Board, ELAP map of accredited laboratories.

California does not regulate the water quality of private domestic wells (State Water Board fact sheet).

If no local lab suits you, mail-in kits from certified labs test a wider panel at home; they cost more than a state or county lab.

Treating hard well water

Most households with hard well water install an ion-exchange softener. Test iron and manganese first: above about 0.3 mg/L iron a softener alone is not enough and an iron filter goes in front of it.

Nearby counties

Riverside County11.9 gpgOrange County17.1 gpgLos Angeles County11.6 gpgKern County8.4 gpgSan Diego County14.5 gpgInyo County4 gpg

FAQ

How hard is well water in San Bernardino County, California?

The median well sampled by the USGS in San Bernardino County has 7.6 gpg (130 mg/L as CaCO₃), which is hard. One in ten wells had less than 25 mg/L and one in ten more than 351 mg/L.

Is my own well the same?

Not necessarily. Hardness depends on the rock layer your well draws from and on its depth, so neighbouring wells can differ by a factor of two or more. Only a test of your own water tells you.

How often should I test my well in California?

Every year for coliform bacteria, nitrate, total dissolved solids and pH (EPA and CDC advice), and after floods, repairs or a change in taste or smell. Hardness, iron and manganese once, and again before you buy a softener.

Do I need a water softener for my well?

Recommended if you have a water heater, boiler or tankless unit: it saves repairs and detergent.

Where does this figure come from?

From 6020 samples of 1522 wells measured by the U.S. Geological Survey between 1980 and 2023, retrieved from the Water Quality Portal. We publish a county only when at least 10 wells were sampled.

Source and method

Computed by Water Hardness Atlas from USGS National Water Information System samples (characteristic "Hardness, Ca, Mg", sites of type well, samples since 1980), retrieved 2026-10-29 through the Water Quality Portal. For each well we take the median of its samples, then the median of all wells in the county; wells above 1,000 mg/L (oil, gas or mine brines) are left out. USGS data are in the U.S. public domain. Water Quality Portal query

Well water hardness in California → · California: tap water by city →