Water Hardness Atlas ZIP / postcode

Well water hardness in Solano County, California

16.4 gpg very hard

Private wells in Solano County typically give very hard water: the median well sampled by the U.S. Geological Survey has 16.4 gpg (281 mg/L as CaCO₃).

<6060–120120–180>180 mg/L

Wells differ a lot, even next door: one in ten sampled wells had less than 123 mg/L and one in ten more than 547 mg/L. The figure comes from 84 wells and 96 samples taken between 1980 and 2022 (half of them by 1980).

Most samples are older than ten years. Groundwater hardness comes from the rock the well is drilled into and changes slowly, but your own well can be quite different, so treat this as a regional indication and test your water.

On city or town water instead of a well? Your utility publishes its own figures: Dixon (10.5 gpg), Vacaville (9.7 gpg), Fairfield (10.7 gpg), Davis (26.3 gpg), Rio Vista (3.9 gpg), West Sacramento (2.9 gpg).

What this hardness means for a well household

How to test your well in California

Hardness is only one part of a well test. Federal health agencies advise every private well owner to test regularly:

Use a certified laboratory: California State Water Board, ELAP map of accredited laboratories.

California does not regulate the water quality of private domestic wells (State Water Board fact sheet).

If no local lab suits you, mail-in kits from certified labs test a wider panel at home; they cost more than a state or county lab.

Treating hard well water

At this hardness an ion-exchange softener sized for your household is the usual answer. Test iron, manganese and pH first: well water often needs an iron filter or a pH correction in front of the softener.

Nearby counties

Yolo County14 gpgSacramento County5.3 gpgNapa County5.2 gpgContra Costa County21.3 gpgSan Joaquin County9.3 gpgAlameda County17.7 gpg

FAQ

How hard is well water in Solano County, California?

The median well sampled by the USGS in Solano County has 16.4 gpg (281 mg/L as CaCO₃), which is very hard. One in ten wells had less than 123 mg/L and one in ten more than 547 mg/L.

Is my own well the same?

Not necessarily. Hardness depends on the rock layer your well draws from and on its depth, so neighbouring wells can differ by a factor of two or more. Only a test of your own water tells you.

How often should I test my well in California?

Every year for coliform bacteria, nitrate, total dissolved solids and pH (EPA and CDC advice), and after floods, repairs or a change in taste or smell. Hardness, iron and manganese once, and again before you buy a softener.

Do I need a water softener for my well?

Yes, unless you are only passing through: scale damages appliances within a few years.

Where does this figure come from?

From 96 samples of 84 wells measured by the U.S. Geological Survey between 1980 and 2022, retrieved from the Water Quality Portal. We publish a county only when at least 10 wells were sampled.

Source and method

Computed by Water Hardness Atlas from USGS National Water Information System samples (characteristic "Hardness, Ca, Mg", sites of type well, samples since 1980), retrieved 2026-10-29 through the Water Quality Portal. For each well we take the median of its samples, then the median of all wells in the county; wells above 1,000 mg/L (oil, gas or mine brines) are left out. USGS data are in the U.S. public domain. Water Quality Portal query

Well water hardness in California → · California: tap water by city →