Water Hardness Atlas ZIP / postcode

Well water hardness in Ogle County, Illinois

21.7 gpg very hard

Private wells in Ogle County typically give very hard water: the median well sampled by the U.S. Geological Survey has 21.7 gpg (371 mg/L as CaCO₃).

<6060–120120–180>180 mg/L

Wells differ a lot, even next door: one in ten sampled wells had less than 325 mg/L and one in ten more than 459 mg/L. The figure comes from 59 wells and 123 samples taken between 1989 and 1992 (half of them by 1990).

Most samples are older than ten years. Groundwater hardness comes from the rock the well is drilled into and changes slowly, but your own well can be quite different, so treat this as a regional indication and test your water.

On city or town water instead of a well? Your utility publishes its own figures: Rockford (20.5 gpg).

What this hardness means for a well household

How to test your well in Illinois

Hardness is only one part of a well test. Federal health agencies advise every private well owner to test regularly:

Use a certified laboratory: Illinois EPA, Safe Water Well Initiative (refers to accredited laboratories).

Testing is your own responsibility: no state agency samples existing private wells routinely.

What a test costs (Lake County Health Department)

Bacteria and nitrate$25

Prices as printed by the lab (2026-03-09); check the current fee before you send a sample. Lake County Health Department

If no local lab suits you, mail-in kits from certified labs test a wider panel at home; they cost more than a state or county lab.

Treating hard well water

At this hardness an ion-exchange softener sized for your household is the usual answer. Test iron, manganese and pH first: well water often needs an iron filter or a pH correction in front of the softener.

Nearby counties

Winnebago County21.3 gpgBoone County20.9 gpgRock County, WI19 gpgMcHenry County22.7 gpgKane County0.5 gpgBureau County21.5 gpg

FAQ

How hard is well water in Ogle County, Illinois?

The median well sampled by the USGS in Ogle County has 21.7 gpg (371 mg/L as CaCO₃), which is very hard. One in ten wells had less than 325 mg/L and one in ten more than 459 mg/L.

Is my own well the same?

Not necessarily. Hardness depends on the rock layer your well draws from and on its depth, so neighbouring wells can differ by a factor of two or more. Only a test of your own water tells you.

How often should I test my well in Illinois?

Every year for coliform bacteria, nitrate, total dissolved solids and pH (EPA and CDC advice), and after floods, repairs or a change in taste or smell. Hardness, iron and manganese once, and again before you buy a softener.

Do I need a water softener for my well?

Yes, unless you are only passing through: scale damages appliances within a few years.

Where does this figure come from?

From 123 samples of 59 wells measured by the U.S. Geological Survey between 1989 and 1992, retrieved from the Water Quality Portal. We publish a county only when at least 10 wells were sampled.

Source and method

Computed by Water Hardness Atlas from USGS National Water Information System samples (characteristic "Hardness, Ca, Mg", sites of type well, samples since 1980), retrieved 2026-10-29 through the Water Quality Portal. For each well we take the median of its samples, then the median of all wells in the county; wells above 1,000 mg/L (oil, gas or mine brines) are left out. USGS data are in the U.S. public domain. Water Quality Portal query

Well water hardness in Illinois → · Illinois: tap water by city →