Water Hardness Atlas ZIP / postcode

Well water hardness in Pemiscot County, Missouri

1.6 gpg soft

Private wells in Pemiscot County typically give soft water: the median well sampled by the U.S. Geological Survey has 1.6 gpg (28 mg/L as CaCO₃).

<6060–120120–180>180 mg/L

Wells differ a lot, even next door: one in ten sampled wells had less than 21 mg/L and one in ten more than 276 mg/L. The figure comes from 11 wells and 17 samples taken between 1981 and 2018 (half of them by 1986).

Most samples are older than ten years. Groundwater hardness comes from the rock the well is drilled into and changes slowly, but your own well can be quite different, so treat this as a regional indication and test your water.

What this hardness means for a well household

How to test your well in Missouri

Hardness is only one part of a well test. Federal health agencies advise every private well owner to test regularly:

Use a certified laboratory: Missouri DNR list of certified laboratories (chemical and microbiological; certification is not required for private well samples).

Missouri does not require testing of existing private wells; state rules cover only well construction and installation (Missouri DHSS).

What a test costs (Missouri State Public Health Laboratory (handling fee for private well bacteria test))

Total coliform and E. coli (handling fee)$10

Prices as printed by the lab (2026-10-29); check the current fee before you send a sample. Missouri State Public Health Laboratory (handling fee for private well bacteria test)

If no local lab suits you, mail-in kits from certified labs test a wider panel at home; they cost more than a state or county lab.

Treating hard well water

Water this soft needs no softener. Soft well water can be corrosive, though: test pH, lead and copper if you see blue-green stains.

Nearby counties

Dunklin County2 gpgNew Madrid County9.7 gpgLauderdale County, TN8.8 gpgGibson County, TN1.1 gpgScott County8.3 gpgCraighead County, AR8.6 gpg

FAQ

How hard is well water in Pemiscot County, Missouri?

The median well sampled by the USGS in Pemiscot County has 1.6 gpg (28 mg/L as CaCO₃), which is soft. One in ten wells had less than 21 mg/L and one in ten more than 276 mg/L.

Is my own well the same?

Not necessarily. Hardness depends on the rock layer your well draws from and on its depth, so neighbouring wells can differ by a factor of two or more. Only a test of your own water tells you.

How often should I test my well in Missouri?

Every year for coliform bacteria, nitrate, total dissolved solids and pH (EPA and CDC advice), and after floods, repairs or a change in taste or smell. Hardness, iron and manganese once, and again before you buy a softener.

Do I need a water softener for my well?

No. With soft water a softener adds nothing.

Where does this figure come from?

From 17 samples of 11 wells measured by the U.S. Geological Survey between 1981 and 2018, retrieved from the Water Quality Portal. We publish a county only when at least 10 wells were sampled.

Source and method

Computed by Water Hardness Atlas from USGS National Water Information System samples (characteristic "Hardness, Ca, Mg", sites of type well, samples since 1980), retrieved 2026-10-29 through the Water Quality Portal. For each well we take the median of its samples, then the median of all wells in the county; wells above 1,000 mg/L (oil, gas or mine brines) are left out. USGS data are in the U.S. public domain. Water Quality Portal query

Well water hardness in Missouri → · Missouri: tap water by city →