Water Hardness Atlas ZIP / postcode

Well water hardness in Brown County, Nebraska

4.3 gpg moderately hard

Private wells in Brown County typically give moderately hard water: the median well sampled by the U.S. Geological Survey has 4.3 gpg (73 mg/L as CaCO₃).

<6060–120120–180>180 mg/L

Wells differ a lot, even next door: one in ten sampled wells had less than 41 mg/L and one in ten more than 176 mg/L. The figure comes from 28 wells and 120 samples taken between 1980 and 2003 (half of them by 1993).

Most samples are older than ten years. Groundwater hardness comes from the rock the well is drilled into and changes slowly, but your own well can be quite different, so treat this as a regional indication and test your water.

What this hardness means for a well household

How to test your well in Nebraska

Hardness is only one part of a well test. Federal health agencies advise every private well owner to test regularly:

Use a certified laboratory: Nebraska DHHS list of certified laboratories (certification numbers and certified analytes).

Testing is your own responsibility: no state agency samples existing private wells routinely.

What a test costs (Nebraska DHHS Public Health Environmental Laboratory)

Nitrate sample kit (plus postage)$16

Prices as printed by the lab (2024-03-08); check the current fee before you send a sample. Nebraska DHHS Public Health Environmental Laboratory

If no local lab suits you, mail-in kits from certified labs test a wider panel at home; they cost more than a state or county lab.

Treating hard well water

A softener is optional at this level. Check iron and manganese in your test as well: staining from them is a more common well problem than hardness.

Nearby counties

Tripp County, SD8.8 gpgGregory County, SD14.2 gpgCherry County2.9 gpgHolt County6.5 gpgTodd County, SD8.2 gpgMellette County, SD13.7 gpg

FAQ

How hard is well water in Brown County, Nebraska?

The median well sampled by the USGS in Brown County has 4.3 gpg (73 mg/L as CaCO₃), which is moderately hard. One in ten wells had less than 41 mg/L and one in ten more than 176 mg/L.

Is my own well the same?

Not necessarily. Hardness depends on the rock layer your well draws from and on its depth, so neighbouring wells can differ by a factor of two or more. Only a test of your own water tells you.

How often should I test my well in Nebraska?

Every year for coliform bacteria, nitrate, total dissolved solids and pH (EPA and CDC advice), and after floods, repairs or a change in taste or smell. Hardness, iron and manganese once, and again before you buy a softener.

Do I need a water softener for my well?

Not essential; a scale inhibitor protects the heater cheaply.

Where does this figure come from?

From 120 samples of 28 wells measured by the U.S. Geological Survey between 1980 and 2003, retrieved from the Water Quality Portal. We publish a county only when at least 10 wells were sampled.

Source and method

Computed by Water Hardness Atlas from USGS National Water Information System samples (characteristic "Hardness, Ca, Mg", sites of type well, samples since 1980), retrieved 2026-10-29 through the Water Quality Portal. For each well we take the median of its samples, then the median of all wells in the county; wells above 1,000 mg/L (oil, gas or mine brines) are left out. USGS data are in the U.S. public domain. Water Quality Portal query

Well water hardness in Nebraska → · Nebraska: tap water by city →