Well water hardness in Deschutes County, Oregon
3.2 gpg soft
Private wells in Deschutes County typically give soft water: the median well sampled by the U.S. Geological Survey has 3.2 gpg (54 mg/L as CaCO₃).
Wells differ a lot, even next door: one in ten sampled wells had less than 27 mg/L and one in ten more than 254 mg/L. The figure comes from 71 wells and 135 samples taken between 1991 and 2000 (half of them by 1995).
Most samples are older than ten years. Groundwater hardness comes from the rock the well is drilled into and changes slowly, but your own well can be quite different, so treat this as a regional indication and test your water.
What this hardness means for a well household
- Little or no limescale in kettles, water heaters or washing machines.
- Soap lathers easily; water does not dry skin or hair.
- Dishwasher: salt setting at minimum or off.
- No softener needed; a jug filter only changes taste.
How to test your well in Oregon
Hardness is only one part of a well test. Federal health agencies advise every private well owner to test regularly:
- Test a private well every year for total coliform bacteria, nitrates, total dissolved solids and pH; test more often if young children, older adults or a pregnant or nursing person live in the home. (US EPA, Protect Your Home's Water)
- Test at least once a year and ask the local health department which other germs or chemicals matter where you live. (CDC, Guidelines for Testing Well Water)
- Test every year for coliform bacteria and nitrate, and whenever the water changes in appearance, odor or taste, using a state-certified drinking water laboratory. (Oregon Health Authority, Private Well Fact Sheet (updated May 2023))
Use a certified laboratory: Oregon Health Authority, Drinking Water Services: laboratory lists (ORELAP-accredited drinking water labs).
Under the Oregon Domestic Well Testing Act, when a property with a domestic well is sold or exchanged the seller must test the water for arsenic, nitrate and total coliform bacteria at an accredited lab; results are valid for one year.
If no local lab suits you, mail-in kits from certified labs test a wider panel at home; they cost more than a state or county lab.
Treating hard well water
Water this soft needs no softener. Soft well water can be corrosive, though: test pH, lead and copper if you see blue-green stains.
Nearby counties
FAQ
How hard is well water in Deschutes County, Oregon?
The median well sampled by the USGS in Deschutes County has 3.2 gpg (54 mg/L as CaCO₃), which is soft. One in ten wells had less than 27 mg/L and one in ten more than 254 mg/L.
Is my own well the same?
Not necessarily. Hardness depends on the rock layer your well draws from and on its depth, so neighbouring wells can differ by a factor of two or more. Only a test of your own water tells you.
How often should I test my well in Oregon?
Every year for coliform bacteria, nitrate, total dissolved solids and pH (EPA and CDC advice), and after floods, repairs or a change in taste or smell. Hardness, iron and manganese once, and again before you buy a softener.
Do I need a water softener for my well?
No. With soft water a softener adds nothing.
Where does this figure come from?
From 135 samples of 71 wells measured by the U.S. Geological Survey between 1991 and 2000, retrieved from the Water Quality Portal. We publish a county only when at least 10 wells were sampled.
Source and method
Computed by Water Hardness Atlas from USGS National Water Information System samples (characteristic "Hardness, Ca, Mg", sites of type well, samples since 1980), retrieved 2026-10-29 through the Water Quality Portal. For each well we take the median of its samples, then the median of all wells in the county; wells above 1,000 mg/L (oil, gas or mine brines) are left out. USGS data are in the U.S. public domain. Water Quality Portal query
Well water hardness in Oregon → · Oregon: tap water by city →